Myalarm D10024 Instalační příručka stáhnout pdf (Strana 19)

D10024

D10024 Operator’s Guide

4.4.4 Print Functions

To enter the Print Menu, select 6) Print from the Main Menu. This menu controls the operation of the front panel printer

(if installed).

PRINT: 1) Devices 2) Events 5) Disabled

3) Mode 4) Setup

Figure 17: Print Menu

4.4.4.1 Print Devices

This option allows the operator to print out the current state and the text assigned to all devices on a polling circuit

(loop).

4.4.4.2 Print Events (Event Log)

This option allows the operator to print out the contents of the event log.

4.4.4.3 Print Mode

This option allows the operator to toggle between manual and automatic printing. The current selection is shown on the

Print Menu display. In Manual Mode, the printer prints only on demand. In Automatic Mode, the printer automatically

prints events as they occur.

4.4.4.4 Print Direction

This option allows the operator to change print direction on panel-mounted printers.

4.4.4.5 Print Disabled

This option allows the operator to print the location of all disabled devices.

4.4.5 View Functions

Select 7) View from the Main Menu to enter the View Menu. This menu displays information about the selected option

on the alphanumeric display. After viewing an option, press the [No] key to return to the View Menu. Press the [No] key

again to return to the Main Menu.

VIEW: 1) Device 2) Log 3) Faults

4) Outputs 5) Disablements 6) Sys Events

Figure 18: View Menu

4.4.5.1 View Devices

This option allows the operator to view the current state and text of any device on a circuit.

Select 1) Devices from the View Menu.

The display will prompt for the loop (circuit) number. Key in the circuit number and press [Enter].

The display will then prompt for the address. Key in the address and press [Enter].

4.4.5.2 View Event Log

This option allows the operator to view the Event Log.

Select 2) Log from the View Menu and press [Enter].

The display prompts a beginning entry number. The default is the latest entry. Press [Yes] to accept the prompt.

Press [No] to select another entry. Use the [<] [>] keys to scroll through the log.

Exit this menu by pressing the [No] key.

4.4.5.3 View Faults

This option displays the panel fault status. This is the same display as the normal alphanumeric display without the

logo. The operator may scroll through all the faults using the [<] [>] keys.

Exit this menu by pressing the [No] key.

Control Level 2

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Komentáře k této Příručce

Žádné komentáře

Myalarm D10024 Instalační příručka Strana 19

Komentáře k této Příručce