Myalarm V-LCD1 Manuál s instrukcemi stáhnout pdf (Strana 143)

LCD PROGRAMMING - BATCH ENROLL DATA CHIPS

8-137

System 2 Installation / Programming Manual

Enter Number þþþþ

Enter Chip

Use Up to 4 Digits þþþþ

First User # [ _ _ _ _ ]

Press Any Key

No More Room!

System Function While Batch Loading

IMPORTANT NOTE: The system will not process door inputs while batch loading is in

operation. This means that users entering their code at a door will not be granted access while

the system is batch loading. For this reason, it is important that batch loading be performed at

non-peak times so as to minimize user inconvenience.

At this point, the LCD will scroll the following instructions:

Scrolling Options: Touch Data Chip

Enter Chip Number

Use Bckspc to correct

0=Quit

Keep touching all the Data Chips you wish to program. The actual code will not print on the

LCD... but, if you look closely the LCD will advance to the same prompt until you are finished.

Be sure to “List Users” (Option 12) after you have programmed all you Data Chips into the

System.

If you wish to re-enter Data Chips, and you do not have them “in-hand”, you must have the full

16-digit code. This code will print when you List Users. Since the code contains alphanumeric

characters a PC or VDT is also needed to re-enter these chips.

After you Batch Enrolled these Data Chips the LCD will scroll:

Scrolling Options: 0=Quit

If you wish to batch program additional users, enter the desired first user number followed by a

# (enter) at the First User # [ _ _ _ _ ] prompt. If you are finished batch programming users

press 0 and # (enter).

Memory Full

At some point, you may enter the maximum number of users supported on your version of

System 2. Should this happen, the LCD will scroll the instructions:

You now have a decision to make. Either remove any unused codes, or call Corby about

purchasing the memory expansion option. After you have successfully entered all users, the

unit will return to the Main Menu.

1 2 ... 138 139 140 141 142 143 144 145 146 147 148 ... 335 336

Žádné komentáře

Myalarm V-LCD1 Manuál s instrukcemi Strana 143