Myalarm V-LCD1 Manuál s instrukcemi stáhnout pdf (Strana 93)

LCD PROGRAMMING - AUXILIARY OUTPUTS

8-87

System 2 Installation / Programming Manual

Enter 1 thru 255 Seconds

Momentary Time [ _ _ 2]

1 = System Reset þþþþ

Event (0 for None) [ _ 0 ]

Momentary Time

If you chose momentary, the LCD will scroll the instructions:

At the Momentary Time [ _ _ 2] prompt, enter your selection followed by # (enter). You do

not need to enter three digits here. A two is all that is needed to program this Port / Door for

two seconds.

Trigger Event

As we mentioned above, an output can be triggered by a System event. Example: If you are

programming Auxiliary Relay #1, and want it to activate when an invalid code is used at one of

the readers, select 11 - Inv Code. You can now wire this Relay to a light, bell, whistle, etc. and

each time there is an invalid code Auxiliary Relay #1 will activate.

If you do not wish these outputs to activate from any System event, press 0.

At this point, you may select which event, if any, will trigger this output.

The LCD will scroll the instructions:

Scrolling Options: 2 = AC Off

3 = AC On

4 = Memory Clear

5 = Relay Override

6 = Door Ajar

7 = Door Closed

8 = Forced Entry

9 = Valid User

10= Inv

11 = Inv Code

12 = PIN Error

13 = Sched Error

14 = Request To Exit

15 = Unknown Event

16 = AP Error

17 = Door Perm

18 = Daylight Savings

19 = Power up

20 = Zone On

21 = Zone Off

At the Event (0 for None) [ _ 0 ] prompt, enter your selection followed by # (enter).

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 335 336

Žádné komentáře

Myalarm V-LCD1 Manuál s instrukcemi Strana 93