Myalarm V-LCD1 Manuál s instrukcemi stáhnout pdf (Strana 43)

INSTALLATION

5-37

System 2 Installation / Programming Manual

Proximity Readers

Overview

Corby Proximity Cards are read when they are brought within reading distance of a Card Reader, typically 3”-

36” depending upon the style of the reader. It is not necessary for the Card to have physical contact with the

Card Reader for a read to occur.

Corby Proximity Readers are available in a variety of indoor and outdoor versions.

When a Proximity Card is presented to the reader, it is triggered into a transmission mode and the Card

transmits a 30 bit digital signal to the reader by means of an electrostatic coupling. Proximity Cards do not

have batteries to restrict their life but instead receive power to transmit as part of the trigger signal from the

Card Reader. When a valid Card is presented the LED will flash and then turn to a steady green status for the

relay time duration.

Unlike other Proximity systems which use resonant circuits as code elements, Corby/Indala ASP Cards

actually contain miniature CMOS circuits. These cards can also be read while still in a wallet or purse. In

addition, readers may be installed behind walls for enhanced security, and some models may be mounted on a

solid metal surface. Readers should not be mounted within a few feet of a PC monitor or Video Display

Terminal (VDT) since this may reduce the read range.

Proximity Reader Styles

Standard size readers measure 5.5 X 4.5 inches. They are surface mountable and protrude 1.375 inches from

the mounting surface. Typical read distance is 5-8 inches but this may vary depending on the installation.

There is an outdoor weatherproof version and an indoor version. Both have a bicolor LED and beeper for

audible status.

Wiegand size proximity readers measure 5.25 X 2.25 inches. They are surface mountable and protrude 1.5

inches from the wall. These readers are designed to replace a standard Wiegand style swipe reader. Read

distance is up to 4 inches. This is an indoor and outdoor reader in black only. This style reader may be

mounted on a metal surface.

Switchplate size readers are also available. This reader measures 3 X 4.625 inches and protrudes .5 inches

from the mounting surface. Read distance is approximately 4-5 inches. This unit is beige in color. A bicolor

LED indicator and beeper is included. This unit may be mounted to a single gang metal electrical junction box

or on a flat wall. It will not operate on a solid metal surface. This unit is not for outdoor use.

Mullion size readers are only 1.6” wide and 5.5 “ high which means they will fit most 1.75” wide aluminum

storefront door frames. The reader protrudes .5 inches from the door frame. Typical read distance is 3-4

inches. The reader (black) has a built-in bicolor LED indicator and beeper. These units are specifically

designed to operate outdoors on a metal surface but will also operate on non-metallic surfaces.

Switchplate and mullion style readers best reading will occur by moving the card or tag at any convenient angle

toward the reader rather than swiping it across. A slight read delay of approximately one second is normal.

Hold the Card parallel to the reader within the read range and pull the Card away. The Card Reader LED

will flash (and beeper sound - if connected) then the LED will switch to green indicating a valid card was read.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 335 336

Myalarm V-LCD1 Manuál s instrukcemi Strana 43