Myalarm V-LCD1 Manuál s instrukcemi stáhnout pdf (Strana 221)

PC/VDT PROGRAMMING - BATCH ENROLL KEYPAD CODES

9-215

System 2 Installation / Programming Manual

Note: Although the display states the Option is Not Active, the output(s) have been assigned to the selected schedule.

However, it will not activate until the Second Door has been turned ON. Proceed to Option #13 to turn this Option ON.

The unit assigns this output to the schedule for those customers who wish to upgrade a one-door system (2003) to a two-

door system (2016) in the future, but do not wish to re-program the outputs.

Additional Outputs

When a valid code is entered, the door relay for that Port will be activated. In addition to this

activation, you might want other outputs to be activated to sound an alarm, trip a dialer, or send

some other signal. There are four such outputs from which to choose. The Port programming

section of this manual details the physical properties of the outputs. Any, all, or none of these

outputs may be activated by a valid code entry if the Second Door is activated. Refer to Option

#13 to purchase this option.

The VDT will display the instructions:

Assign These Output(s)

to User ID

1=Aux Relay 1

2=Aux Relay 2

3=Voltage Output 1

4=Voltage Output 2

0=None

Outputs [----]

At the Outputs [----] prompt, enter the desired output(s), if any, then press ENTER.

Example: If you select 1 (Auxiliary Relay 1) and 3 (Voltage Output 1) after someone in this

group enters a valid code or uses a valid Card the door will be activated and the Auxiliary Relay

#1 and Voltage Output #1 will activate.

If you select any of these Outputs and you have not activated the Second Door the VDT will

display:

Option Not Active

Install in Option 13

Press Any Key

1 2 ... 216 217 218 219 220 221 222 223 224 225 226 ... 335 336

Žádné komentáře

Myalarm V-LCD1 Manuál s instrukcemi Strana 221