Myalarm V-LCD1 Manuál s instrukcemi stáhnout pdf (Strana 272)

TROUBLESHOOTING

12-266

System 2 Installation / Programming Manual

Door Ajar & Forced Entry messages appear without being wired

Possible Cause:

U When the system is first initialized, and whenever you press the reset button or let the system

time out of programming by itself, you will see those messages, along with other messages,

appear on the LCD.

U Possible noise problem due to the wire runs. Make sure the card reader or keypad wire runs

are at least one foot away from AC lines, phone lines and flourescent lighting.

When I hook up and test a Door Ajar or Zone contact, no relay

activates

Possible Cause:

U The Auxiliary outputs in option 6 have not been programmed to activate from those events.

The “#” sign isn’t clearing my mistakes like it does on other Corby

Systems

Possible Cause:

U The “#” sign isn’t the “clear” button anymore - the “x” sign is.

The keypad I hooked up doesn’t work

Possible Cause:

U Verify you used the appropriate header for the keypad

U Make sure the black wire on the header lines up with the red wire label, on the keypad

printed circuit board.

U Make sure you have the system programmed for keypads not cards.

U When you are using a keypad code, remember to press “x”, first. Then type in your code,

and press “#”

When I swipe a card, I get nothing on the LCD display

Possible Cause:

U The system may not be set for cards (see option 4 in programming)

U The port parameters may not be set for “Card Only” (see option 5 in programming)

U Make sure the port doesn’t have any time-schedules on it - you can work on that later. (see

option 5)

U The Data 1/Data 0 wires going out to the card reader may be reversed.

1 2 ... 267 268 269 270 271 272 273 274 275 276 277 ... 335 336

Žádné komentáře

Myalarm V-LCD1 Manuál s instrukcemi Strana 272