Myalarm V-LCD1 Manuál s instrukcemi stáhnout pdf (Strana 188)

PC/VDT PROGRAMMING - SELECT CARD TYPE

9-182

System 2 Installation / Programming Manual

Select Card Type (Option #4)

System 2 can accept five different reader technologies: Data Chip, Mag-Stripe, Bar Code,

Wiegand or Proximity. This is where you specify which input device you are using. Note, that

if you choose Option #5 (16 Digit Mag, Bar Code) your standard reader will accept 16 digit

cards. In the case of a magnetic stripe reader, it will accept any standard bank card or credit

card.

You do not need to enter this option if you are only using Keypads.

Skip this option or press 0 = No Cards (this is the default).

You can choose the input type from the following prompt:

1=DataChip

2=Mag or Bar Code

3=Wiegand or Prox

4=26 Bit Wiegand

5=16 Digit Mag, Bar Code

0=No Cards

Card Type [0]

At the Card Type [0] prompt choose the desired type.

If you are using Data Chip choose 1; Magnetic Stripe or Bar Code Readers choose 2;

Corby Wiegand or Proximity Readers choose 3 and 26 Bit Wiegand choose 4.

Never mix different kinds of Cards in this unit. You may not have a Bar-Code Card and

Data Chips, or Wiegand Cards and Data Chips, or any other combination! The System can only

handle one common type of Card. However, any single card type may be combined with a

keypad. When you pick your Card type you must stick with it or Clear Users and start over.

1 2 ... 183 184 185 186 187 188 189 190 191 192 193 ... 335 336

Žádné komentáře

Myalarm V-LCD1 Manuál s instrukcemi Strana 188