Myalarm V-LCD1 Manuál s instrukcemi stáhnout pdf (Strana 88)

LCD PROGRAMMING - PORT CONFIGURATION

8-82

System 2 Installation / Programming Manual

Use 01 thru 16 þþþþ

Enter Port # [ 0 ]

Option Not Active þþþþ

Press Any Key

Note: Although the display states the Option is Not Active, the second door can be set-up. However, it

will not be activated unless the 2nd Door Option has been turned ON. Proceed to Option #13 to turn

this Option ON.

The unit assigns the programmed information to the second door for those customers who wish to add the

second door in the future, but do not wish to re-program this option.

Enter 1, 2, 3, or 4 þþþþ

Input Device(s) [ 1 ]

Selecting the Port to Program

The LCD will scroll the following instructions:

Scrolling Options: 0=Quit

At the Enter Port # [ 0 ] prompt, enter the Port you want to work on and # (enter).

Note: If you have set-up the System for Networking, the number of ports available is 16.

If you select Port #2 and you have not activated the 2nd door the LCD will scroll:

Scrolling Options: Install in Option 13

This same prompt will appear if you try to program any other ports which you have not

activated (Ports 3 - 16). You will need to purchase the Network Option (refer to Option #13)

to enable any doors beyond two.

Selecting the Input Device(s)

Each System 2 Port can accept a Keypad Input, Card Input, Keypad AND Card Input or

Keypad OR Card Input. In AND mode both a valid Keypad code and a valid Card must be

entered. In OR mode either may be used for access.

If you selected 0=No Cards in Option #4 you will not see this prompt. Skip to Selecting Relay

Type.

You can choose the mode at the following prompt:

Scrolling Options: 1=Keypad Only

2=Card Only

3=Card AND Keypad

4=Card OR Keypad

At the Input Device(s) [ 1 ] prompt choose the desired type.

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 335 336

Žádné komentáře

Myalarm V-LCD1 Manuál s instrukcemi Strana 88